Whether you have a gas furnace, an oil furnace, or an electric furnace, knowing how to reset a furnace is an important skill. A reset button is usually found within the blower housing adjacent to the blower motor in almost every furnace.
Having a reset button on your furnace is an important part of your HVAC system. It is designed to shut the unit off quickly, ensuring your home is heated safely. Your furnace is likely overheating if your furnace reset button keeps tripping. There may be a need for furnace repair services in this case.
3 Easy steps to restart your furnace
- Change The Filters: Make sure the furnace filter is clean before doing anything. Many new HVAC models have safety mechanisms that prevent the furnace from starting if the filter is clogged. Several problems are associated with dirty air filters, including restricted airflow and poor indoor air quality. Ensure your HVAC filter is clean or replaced no more than 90 days after installation.
Follow the below steps to change a furnace filter:- Set the thermostat to off mode.
- An air filter is usually located in a furnace’s top or bottom compartment.
- You can slide the filter out once you’ve found the access panel.
- Place the new, clean filter in the furnace with the arrows pointing toward the airflow.
- Make sure the access door is closed and secured.
- Check the Pilot Light: If your furnace’s pilot light is out, it can’t ignite the spark it needs to light the boilers. In some cases, you may need to remove a panel to check if the pilot light is on, but in many cases, you can just glance inside. Having turned off your pilot light, you will need to relight it. You can relight the pilot light according to your owner’s manual instructions.
The next step is turning the furnace off and back on again after ensuring the filter is clean, and the pilot light is working. If you happen to live in Aurora, Co get in touch with Technic Air Mechanical and speak to our professional for furnace replacement.
- Turn The Furnace Off and On: The house’s indoor temperature should be at least five degrees lower than the thermostat’s temperature. After finding the breaker box, proceed to the next step. You need to locate the breaker for your heater and turn it off. You should make sure that your hands are completely dry before you start. If you notice damage to the breaker panel, do not use it. Contact our qualified electrician if there is any noticeable damage.
It is also important to understand that there may be an HVAC subpanel near the outdoor unit that contains the breakers. If the system is off and rebooting, leave the breaker for at least 10 minutes. After 10 minutes, turn the HVAC breaker back on. Once your furnace has been restored to power, turn the temperature above room temperature and set your thermostat to heat mode.
If you are looking for HVAC service near me, contact Technic Air Mechanical. For any HVAC service you require, we’ll be happy to help and provide solutions.
